Random good picture Not show

31) Numerical simulation technology has been carried out to analyze the filling process of an aluminum alloy wheel produced by low pressure die casting.

32) Die Castings, Plastic Moulding, Die Casting, Chrome Plating, Plastic Moulding, Presswork Die Castings.

33) In the design of die casting die screw thread screw thread unloading is a difficult point.

34) Companies specializing in renovation of die casting machine, hot - room, cold room machine.

35) Casting parts mainly include casting die casting, gravity casting, precision casting etc.

36) The die construction , running principle and features, technological process flow, technique parameters and product performance of aluminum alloy integral naves by gravity die casting are described.

37) The first magnesium alloy die casting machine designed by the group is an unprecedented case nationally.

38) Changes in hydrogen content in liquid aluminum were measured under different relative humidity of compressed air in low pressure die casting.

39) Heat treatment of pressure die casting is not possible but due to the high rate of solidification the mechanical properties are good.

40) The results showed that although the vacuum smelting has strongly degassing capacity, the degassing effects is relevant to the relative humidity of compressed air in low pressure die casting.

41) Three heat transfer mathematical models are given based on working condition of horizontal cold chamber die casting machine.

42) A new casting technology for inlet manifold in tilt casting machine gravity die casting was described.

42) Sentencedict.com try its best to gather and create good sentences.

43) The die design and technique of gravity die casting process for driven belt wheel are introduced. The causes and corresponding resolving methods of some typical defects are analyzed.

44) The practical structure of die casting mould with the rotational automatic thread demoulding for shell parts, the calculation of mode locking force and the process parameters were presented.

45) Computer simulation was employed to optimize filling system to predict filling process and prevent the defects for Al alloy automotive parts in semi-solid die casting.

46) The position of overflow and thicker inner gate was optimized to reduce the probabilities of cold shut, flow marks and slag. Furthermore, the surface quality of the die casting improves.

47) It has elaborated the advantages replacing die casting and common die forging with semisolid die forging.

48) Structural evolutions of ZL 112 Y die cast alloy in procedures of semi - solid die casting were investigated.

49) The temperature and stress fields of a thin-walled magnesium component in high pressure die casting(HPDC) can not be investigated optically but can be performed shown by numerical simulation.

50) A study of optimization is made to the mold filling simulation on low pressure die casting for automobile wheel casting.

51) Welcome advice, and, Wing On die casting machine - better!

52) The newly developed method of gating system design for zinc alloy in die casting is introduced.

53) This new model is designed to predict die erosion due to cavitation during filling in high pressure die casting.

54) Be familiar with stamping, machining, injection molding, die casting, and finishing process, inspection gauge, weld fixture.

55) By 1920, the earliest cold chamber die casting machine was published.

56) I plant with large, medium and small molding machine. Blister machine, aluminum die casting machine multiple.

57) A die casting die with pumping crossed cores by crossed compound dog-led cams and hydraulic pressure is used for cupulate parts with inboard concave.

58) A new casting technology for inlet manifold in tilt casting machine for gravity die casting was described.

59) So far the largest domestic zinc alloy die casting machine room of professional producers.

60) During die casting, core deformation resulting in batches rejected castings is very easy.